Sensor - Ride Height - Rear - LH (Remove and Replace)
Correction code
31103002
0.42
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Raise and support the vehicle.
- Remove the LH front wheel. See Wheel Assembly (Remove and Install).
- Disconnect the electrical connector from the LH rear ride height sensor.
-
Remove the bolt that attaches the LH
rear ride height sensor to the suspension arm.
Note1x bolt, 10mm, 5 Nm, 1x datum
-
Remove the bolt that attaches the LH
rear ride height sensor to the subframe, and then remove the sensor from the
vehicle.
Note1x bolt, 10mm, 5 Nm, 1x datum, Remove assembly
Install
-
Install the bolt that attaches the LH
rear ride height sensor to the subframe.
Note1x bolt, 10mm, 5 Nm, 1x datum
-
Install the bolt that attaches the LH
rear ride height sensor to the suspension arm.
Note1x bolt, 10mm, 5 NmCAUTIONDo not bind or invert the orientation of the sensor arm.
- Connect the electrical connector to the LH rear ride height sensor.
- Install the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift.
- Perform a ride height adjustment. See Ride Height (Adjust).