Platter Enclosure Coolant (Drain) (On Table)
Correction code
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Procedure
-
Remove the plug from the HV battery
coolant supply fitting (left), immediately connect the battery flush adapter to the
fitting, and then perform a Push-Pull-Push test of the fittings.
-
Connect the coolant cart flush hose to
the coolant cart regulator.
-
Make sure that the coolant cart
regulator valve is in the closed (vertical) position.
-
Connect the coolant cart flush hose to
the battery flush adapter.
-
Make sure that the P2 battery drain
adapter valve is in the closed (perpendicular to adapter) position.
-
Remove the plug from the HV battery
coolant return fitting (right), immediately connect the P2 battery drain adapter to the
fitting, and then perform a Push-Pull_Push test of the fittings.
-
Connect the coolant cart drain hose to
the coolant drain container.
-
Connect the coolant cart drain hose to
the P2 battery drain adapter.
-
Turn the valve on the P2 battery drain
adapter to the open (parallel to adapter) position.
-
Connect the supply air hose to the
coolant cart supply air connector.
-
Slowly turn the pressure regulator
valve to the open (horziontal) position, and allow coolant to drain out of the HV
battery enclosure.
-
After the coolant has drained, turn
the pressure regulator valve to the closed (vertical) position.
-
Disconnect the supply air hose from
the coolant cart supply air connector.
-
Turn the valve on the P2 battery drain
adapter to the closed (perpendicular to adapter) position.
-
Remove the coolant cart drain hose
from the P2 battery drain adapter.
-
Remove the coolant cart drain hose
from the coolant drain container.
-
Release the clip, and then disconnect
the P2 battery drain adapter from the HV battery coolant return fitting (right).
-
Disconnect the coolant cart flush hose
from the battery flush adapter.
-
Disconnect the coolant cart flush hose
from the coolant cart regulator.
-
Release the clip, and then disconnect
the battery flush adapter from the HV battery coolant supply fitting (left).