2023-05-18

Fairing - Rocker Panel - Rear - LH (Remove and Replace)

Correction code 12202202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the lower push clips (x2) that attach the LH rocker panel to the rear wheel arch liner.
  2. Remove the bolts (x2), then release the tabs (x5) that attach the LH rear rocker panel fairing to the body, and then remove the fairing from the vehicle.
    2.85 Nm (2.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket

Install

  1. Secure the tabs (x5), and then install the bolts (x2) that attach the LH rear rocker panel fairing to the body.
    2.85 Nm (2.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  2. Install the lower push clips (x2) that attach the LH rocker panel to the rear wheel arch liner.