2026-01-30

Bracket - License Plate - Front (AU) (2025+) (Remove and Replace)

Correction code TBD FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-30: Newly released procedure.
Informational PurposesAn informational icon, calling your attention
Note
This procedure describes work that is specific to 2025+ Model S.

Remove

  1. Remove the self tapping bolts (x2) that attach the front license plate to the vehicle body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Socket 1/4in Dr. 6pt. Std. x 8mm

Install

  1. Clean surface area on front fascia for front license plate bracket installation.
  2. Install the self tapping bolts (x2) that attach the front license plate to the vehicle body.
    0.83 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align front license plate bracket onto front fascia, Install bolts securing front license plate bracket onto fascia.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • WIHA Torque Screwdriver 0.8-5Nm
    • ADAPTER, SOCKET HOLDER 1/4"
    • Socket 1/4in Dr. 6pt. Std. x 8mm