Air Extractor - Rear - Outer - LH (Remove and Replace)
    
     Correction code
    
                                    10014602
                                    0.72
                                    
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
    Correction code
    
                                    10014602
                                    0.72
                                    
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
    
  
Remove
- Remove the rear fascia assembly. See Fascia Assembly - Front (Remove and Install).
- 
          Release the tabs (x4) that attach the
            LH outer rear air extractor to the vehicle, and then remove the air extractor from the
            vehicle.
          NoteRelease the tabs from inside the trunk.
Install
- 
          Position the LH outer rear air
            extractor onto the vehicle, and then install the tabs (x4) that attach the air extractor
            to the vehicle.
          
- Install the rear fascia assembly. See Fascia Assembly - Front (Remove and Install).