17/06/2022 13:14:03

Bracket - Pivot - Outboard - 2nd Row Seat - LH (Remove and Replace)

Correction code 13057542 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace) .
  2. Release the LH body harness from the LH 2nd row seat outboard pivot bracket.
  3. Remove the bolts (x2) that attach the LH 2nd row seat outboard pivot bracket to the vehicle, and then remove the bracket from the vehicle.
    26 Nm (19.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Slightly pull the side trim to access the rear bolt.
    Tip: Use of the following tool(s) is recommended:
    • 11 mm socket

Install

  1. Position the LH 2nd row seat outboard pivot bracket into the vehicle, and then install the bolts (x2) that attach the bracket to the vehicle.
    26 Nm (19.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Slightly pull the side trim to access the rear bolt.
    Tip: Use of the following tool(s) is recommended:
    • 11 mm socket
  2. Install the LH body harness onto the LH 2nd row seat outboard pivot bracket.
  3. Install the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace) .