17/06/2022 13:29:58

Actuator - Duct - Floor - 2nd Row (Remove and Replace)

Correction code 18109712 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the RH footrest panel. See Panel - Footrest - Front Passenger (LHD) (Remove and Replace).
  2. Remove the RH toeboard bracket. See Bracket - Toeboard - RH (Remove and Replace).
  3. Disconnect the electrical connector at the 2nd row floor duct actuator.
  4. Remove the screws (x2) that attach the 2nd row floor duct actuator to the vehicle, and then remove the actuator from the vehicle.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator arm keyed angle upon removal.
    Tip: Use of the following tool(s) is recommended:
    • T20 bit

Install

  1. Position the 2nd row floor duct actuator into the vehicle, and then install the screws (x2) that attach the actuator to the vehicle.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Note the actuator arm keyed angle upon installation matches the actuator.
    Tip: Use of the following tool(s) is recommended:
    • T20 bit
  2. Connect the electrical connector at the 2nd row floor duct actuator.
  3. Install the RH toeboard bracket. See Bracket - Toeboard - RH (Remove and Replace).