2022-06-17

Tesla Badge - Front (Remove and Replace)

Correction code 12050502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Tesla Badge - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x3) that attach the T-badge to the T-badge support
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
  • 4 in extension
  • Torque wrench ¼ in drive hexagon - 1060071-00-A
Reuse

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  3. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  4. Remove the screws (x3) that attach the T-badge to the T-badge support.
    Informational PurposesAn informational icon, calling your attention
    Note
    One fastener is located under the rear lip.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
    • Torque wrench ¼ in drive hexagon - 1060071-00-A

Install

  1. Position the front Tesla T-badge onto the T-badge support, and then install the screws (x3).
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    One fastener is located under the rear lip.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
    • Torque wrench ¼ in drive hexagon - 1060071-00-A
  2. Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  3. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).