Sensor - Ambient Air Temperature (Remove and Replace)
Correction code
18107202
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the front fascia. See Fascia Assembly - Front (Remove and Install).
-
Disconnect the ambient air temperature
sensor electrical connector.
-
Squeeze the retaining arms on the clip
to release the ambient air temperature sensor, and then release the sensor downward to
remove it from the active grill shutter assembly.
Install
-
Align the datum on the ambient air
temperature sensor with the opening in the active grill shutter assembly, and then
install the sensor into the assembly.
-
Connect the ambient air temperature sensor electrical connector.
- Install the front fascia. See Fascia Assembly - Front (Remove and Install).