Antenna Amplifier - FM (Remove and Replace)
Correction code 21300702 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Open the liftgate.
- Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Remove the speaker grill trim. See Grille - Speaker - Liftgate (Remove and Replace).
- Remove the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
-
Disconnect the connectors (x2) to the
FM antenna amplifier.
-
Remove the bolt that attaches the FM
antenna amplifier to the liftgate.Tip: Use of the following tool(s) is recommended:
- T30 bit
-
Carefully pry the FM antenna amplifier
away from the lift game to release the retainer, and then remove the antenna amplifier
from the liftgate.
Install
-
Position the FM antenna amplifier onto
the liftgate, and then press the antenna into the liftgate to seat the retainer.
NoteMake sure the datum is lined up and the retainer clips in securely.
-
Install the bolt that attaches the FM antenna amplifier to the liftgate.Tip: Use of the following tool(s) is recommended:
- T30 bit
-
Connect the connectors (x2) to the FM antenna amplifier.
- Install the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
- Install the speaker grill trim. See Grille - Speaker - Liftgate (Remove and Replace).
- Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Close the liftgate.