Link - Stabilizer Bar - Rear - LH (Remove and Replace)
Correction code 31033402 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Nut that attaches the rear stabilizer bar end link to the knuckle |
|
|
Replace | |
Nut that attaches the stabilizer bar end link to the rear stabilizer bar |
|
|
Replace |
Remove
- On the touchscreen, touch to enable Jack Mode.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
-
Remove the nut that attaches the LH
rear stabilizer bar end link from rear stabilizer bar.
NoteBreak the nut loose, and then counter-hold the ball joint with a 5mm hex to remove the nut.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
- 5 mm hex
-
Remove the nut that attaches the LH
rear stabilizer bar link to the rear knuckle.
NoteBreak the nut loose, and then counter-hold the ball joint with a 5mm hex to remove the nut.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
Install
-
Position the LH rear stabilizer bar
link onto the knuckle assembly, and then install a new nut that attaches the link to the
assembly.NoteCounter-hold the ball joint with a 5mm hex to tighten the nut.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
-
Position the LH rear stabilizer bar
link to the stabilizer bar assembly, and then install a new nut that attaches the link
to the assembly.NoteAdjust the end link to align with stabilizer bar. Move the stabilizer bar up/down to get the correct angle to install end link as needed.NoteCounter-hold the ball joint with a 5mm hex to tighten the nut.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
- 5 mm hex
- Install the LH rear wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.