2022-06-17

Switch - Seat Fold - 2nd Row - LH (Remove and Replace)

Correction code 13020072 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  2. Open the LH rear door and lower the LH rear window.
  3. Remove the LH 2nd row seat back panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).
  4. Remove the LH 2nd row headrest. See Headrest - 2nd Row - LH (Remove and Replace).
  5. Remove the 2nd row 60 seat LH and RH headrest guide locks. See Guide Lock - Headrest - 2nd Row (Remove and Replace).
  6. Release the clip that attaches the 2nd row 60 backrest harness to the seat assembly, and then disconnect the electrical connector.
  7. Release the clips (x2) and fastener that attach the 2nd row LH back side cover to the seat assembly, and then remove the cover from the assembly.
  8. Fold the LH 2nd row seat to the vertical position.
  9. Release the clips (x4) and fasteners that attach the LH 2nd row backrest cushion to the seat assembly, and then remove the cushion from the assembly.
  10. Remove the rivets (x3) and release the clips (x5) that attach the LH 2nd row seat shoulder plastic trim to the seat assembly, disconnect the electrical connector, and then remove the trim from the assembly.
  11. Release the tabs (x2) that attach the LH 2nd row seat fold switch to the shoulder plastic trim, and then remove the switch from the trim.

Install

  1. Install the LH 2nd row seat fold switch into the shoulder plastic trim
  2. Position the LH 2nd row seat shoulder plastic trim onto the seat assembly, connect the electrical connector, and then install the rivets (x3) and clips (x5).
  3. Install the clips (x4) and fasteners that attach the LH 2nd row backrest cushion to the seat assembly.
  4. Fold the LH 2nd row seat to the down position.
  5. Position the 2nd row LH back side cover onto the seat assembly, and then install the clips (x2) and fastener that attach the cover to the assembly.
  6. Install the 2nd row 60 seat LH and RH headrest guide locks. See Guide Lock - Headrest - 2nd Row (Remove and Replace).
  7. Install the LH 2nd row headrest. See Headrest - 2nd Row - LH (Remove and Replace).
  8. Install the LH 2nd row seat back panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).
  9. Raise the LH rear window and close the LH rear door.
  10. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).