Bracket - Support - Rocker Panel - Front - LH (Remove and Replace)
Correction code
12200012
0.42
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH rocker panel scuff plate. See Scuff Plate - Rocker Panel - LH (Remove and Replace).
- Remove the LH rocker panel molding. See Molding - Rocker Panel - LH (Remove and Replace).
-
Remove the bolts (x3) that attach the
LH front rocker panel support bracket to the body, and then remove the bracket from the
vehicle.
3 Nm (2.2 lbs-ft)Tip: Use of the following tool(s) is recommended:- Torx T30 socket
Install
-
Install the bolts (x3) that attach the
LH front rocker panel support bracket to body.3 Nm (2.2 lbs-ft)Tip: Use of the following tool(s) is recommended:
- Torx T30 socket
- Install the LH rocker panel molding. See Molding - Rocker Panel - LH (Remove and Replace).
- Install the LH rocker panel scuff plate. See Scuff Plate - Rocker Panel - LH (Remove and Replace).