17/06/2022 13:40:22

Harness - Adaptive Air Spring Module - Front - LH (Remove and Replace)

Correction code 31100012 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Raise and support the vehicle.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  4. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  5. Remove the underhood storage unit access panel. See Underhood Storage Unit Access Panel (Remove and Replace).
  6. Remove the underhood storage unit. See .
  7. Disconnect the LH front damper harness connector.
  8. Release the clip that attaches the LH front damper harness to the vehicle, and then route the harness towards the LH wheel liner.
  9. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  10. Disconnect the LH damper harness connectors from the LH front air spring module.
  11. Release the clips that attach the LH front damper harness to the solenoid bracket, and then remove the harness from the vehicle.

Install

  1. Position the clips that attach the LH front damper harness to the solenoid bracket and route the harness for installation.
  2. Connect the LH damper harness to the LH front air spring module.
  3. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  4. Route the LH front damper harness from the wheel liner, and position the clip that attaches the harness to the vehicle.
  5. Connect the LH front damper harness connector.
  6. Install the underhood storage unit. See .
  7. Install the underhood storage unit access panel. See Underhood Storage Unit Access Panel (Remove and Replace).
  8. Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  9. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  10. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  11. Remove the vehicle from the lift.