Pinch Sensor - Liftgate - LH (Remove and Replace)
Correction code
11358102
0.10
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
-
Disconnect the LH liftgate pinch
sensor electrical connector.
NoteRotate the connector to access the release tab.
- Remove the clips (x6) that attach the LH liftgate pinch sensor assembly to the liftgate.
- Release the LH liftgate pinch sensor grommet, and then remove the harness from the liftgate.
- Maneuver the LH liftgate pinch sensor assembly around the wedge bumper and then away from the liftgate to remove it from the vehicle.
Install
- Position the LH liftgate pinch sensor assembly into the vehicle.
- Install the LH liftgate pinch sensor harness onto the liftgate, and then secure the grommet.
- Install clips (x6) that attach the LH liftgate pinch sensor assembly to the liftgate.
- Connect the LH liftgate pinch sensor electrical connector.
- Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).