17/06/2022 13:37:35

Speaker - Front Door - LH (Remove and Replace)

Correction code 21210102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  2. Remove the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  3. Disconnect the LH front door speaker electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the tabs on either side of the connector.
  4. Remove the bolts (x4) that attach the LH front door speaker to the door assembly, and then remove the speaker from the door assembly.
    3.5 Nm (2.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • ¼ inch bit

Install

  1. Position the LH front door speaker into the door assembly, and then install the bolts (x4) that attach the speaker to the door assembly.
    3.5 Nm (2.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • ¼ inch bit
  2. Connect the LH front door speaker electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the tabs on either side of the connector.
  3. Install the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  4. Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  5. Close the LH front door.
  6. Check the gap fitment of the LH front door decor to the IP decor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current specifications.
  7. Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  8. Adjust the LH front door trim decor.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Loosen the screw, and then rotate the adjustment nut until the desired specification is reached. Tighten the screw once complete
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 18 mm deep socket
  9. Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  10. Check the gap fitment of the LH front door decor to the IP decor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current specifications.