2025-06-13
Bracket - License Plate - Front (2025+) (Remove and Replace)
Correction code
New
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2025-06-13: Released new procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Note
This procedure describes work that is
specific to 2025+ Model S.
-
Remove front license plate with frame
Note4x screws, PH2, 3 Nm
-
Remove front license plate painted bracket from plinth bracket
Note3x bolts, E10 5-Lobe, 1 Nm
-
Install front license plate painted bracket onto plinth bracket
Note3x bolts, E10 5-Lobe, 1 Nm, Verify part is designed for P3, Design changes have been made to molding to avoid interference with fascia camera
-
Install front license plate with frame
Note4x screws, PH2, 3 Nm