2022-06-17

Seal - Body - Side - Rear - Secondary - LH (Remove and Replace)

Correction code 11700102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Release the clip that attaches the LH secondary rear side body seal to the body, and then release the seal from the body.
  2. Release the clip that attaches the LH secondary rear side body seal to the rocker panel. and then remove the seal from the rocker panel.

Install

  1. Use IPA wipes to clean the surface area of the LH secondary rear side body seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 min of dry time.
  2. Position the LH secondary rear side body seal onto the rocker panel, fasten the clip, and then remove the adhesive backing and adhere the seal onto the rocker panel.
  3. Position the LH secondary rear side body seal onto the body, fasten the clip, and then remove the adhesive backing and adhere the seal onto the body.