17/06/2022 13:31:28

Sensor - Air Temperature - Floor Duct - 2nd Row (Remove and Replace)

Correction code 18109502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the RH center console side panel carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).
  2. Disconnect the 2nd row floor duct air temperature sensor electrical connector.
  3. Release the 2nd row floor duct air temperature sensor from the HVAC assembly, and then remove the sensor from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry the sensor straight out of the HVAC assembly.

Install

  1. Install the 2nd row floor duct air temperature sensor into the HVAC assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the sensor by hand. Make sure the sensor is fully seated into the HVAC assembly.
  2. Connect the 2nd row floor duct air temperature sensor electrical connector.
  3. Install the RH center console side panel carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace).