Aero Seal - Hood (Remove and Replace)
Correction code
11701812
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the hood.
-
Release the clips (x13) that attach
the hood aero seal to the hood, and then remove the seal from the hood.
Install
-
Position the hood aero seal onto the
hood, and then install the clips (x13) that attach the hood seal to the hood.
- Close the hood.