Bracket - Pivot - Inboard - 2nd Row Seat - RH (Remove and Replace)
Correction code
13057512
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the RH 2nd row seat back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).
- Remove the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
-
Remove the bolts (x2) that attach the
RH 2nd row seat inboard pivot bracket to the vehicle, and then remove the bracket from
the vehicle.
20 Nm (14.7 lbs-ft)TIpUse of the following tool(s) is recommended:- 13 mm socket
Install
-
Position the RH 2nd row seat inboard pivot bracket into the vehicle, and then install
the bolts (x2) that attach the bracket to the vehicle.20 Nm (14.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 13 mm socket
- Install the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
- Install the RH 2nd row seat back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).