2022-06-17

Sensor - Level - Windshield Washer Reservoir (Remove and Replace)

Correction code 17501902 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Release the clips (x7) that attach the front portion of the LH front wheel house liner to the vehicle.
  4. Disconnect the washer level sensor electrical connector.
  5. Remove the washer level sensor from the washer reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully pry washer level sensor away from washer bottle and allow washer fluid to drain.
  6. Remove the washer level sensor seal from the sensor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Inspect the seal and replace if damaged.

Install

  1. Install the washer level sensor seal to the washer reservoir
  2. Install the washer level sensor to the reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the washer level sensor to the reservoir with the flat section pointed upward.
  3. Connect the washer level sensor electrical connector.
  4. Install the clips that attach the front portion of the LH front wheel house liner to the vehicle.
  5. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Remove the vehicle from the lift.
  7. Fill the washer fluid reservoir.
    Informational PurposesAn informational icon, calling your attention
    TIp
    The reservoir has a capacity of 4.5 liters.