Back Panel – 2nd Row Seat – RH (Remove and Replace)
Correction code 13082312 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
-
Fold the RH 2nd row seat to the down
position.
NoteIf seat cushion is not present, protect the seat as required.
-
Release the clips (x11) and fastener
that attach the RH 2nd row seat back panel to the seat assembly, and then remove the
back panel from the vehicle.
Install
-
Position the RH 2nd row seat back panel onto the seat assembly, and then install the
clips (x11) and fastener back panel to the seat assembly.
-
Fold the RH 2nd row seat to the upright position.
NoteRemove the seat cushion protection.