Seal - Door - Rear - Margin - C Pillar - LH (Remove and Replace)
Correction code 11701302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Open the LH rear door and lower the LH rear window.
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
-
Release the clips (x3) that attach the
LH C-pillar margin rear door seal to the door assembly, and then remove the margin seal
from the vehicle.
Install
-
Position the LH C-pillar margin rear door seal onto the door assembly, and then
install the clips (x3) that attach the margin seal to the door.
- Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
- Raise the LH rear window and close the LH rear door.