LED - Door - Exterior Handle - Front - LH (Remove and Replace)
Correction code
11454502
0.66
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH front door exterior release handle assembly from the vehicle. See Handle - Exterior Release - Door - Front - LH - Generation 3.0 (Remove and Replace).
-
Disconnect the LH front exterior
handle door LED connector.
-
Release the harness clip, and then
remove the LH front exterior handle door LED from the door handle assembly.
Install
-
Position the LH front exterior handle door LED into the door handle assembly, and
then secure the harness clip.
-
Connect the LH front exterior handle door LED connector.
-
Install the LH front door exterior release handle assembly. See Handle - Exterior Release - Door - Front - LH - Generation 3.0 (Remove and Replace).
NoteIt is only necessary to run the TEST-SELF_VCLEFT_FRONT-L_CALIBRATE-WINDOWvia Toolbox: (link) routine when calibrating the door handle after installation.