2022-06-17

Bracket - Attachment - Fascia - Rear (Remove and Replace)

Correction code 10014302 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).
  2. Remove bolts that attach the rear fascia center bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
    • 4 in extension
    Informational PurposesAn informational icon, calling your attention
    Note
    5x bolts, 10mm, 4 Nm

Install

  1. Position the rear fascia center bracket onto the vehicle, and then install the bolts.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
    • 4 in extension
  2. Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).