Seat Back - 2nd Row - RH (Remove and Replace)
Correction code 13054102 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Open the RH doors and lower the RH windows.
- Move front passenger seat forward.
- Remove the RH 2nd row seat side bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
-
Disconnect the RH 2nd row seat back
harness electrical connector.
-
Release the clip that attaches the RH
2nd row seat back harness to the pivot bracket.
-
Release the RH 2nd row seat back pivot
bushing from the pivot bracket.
-
Slightly tilt the RH 2nd row seat
upward, and then pull the RH 2nd row pivot cast upward to release it from the pivot
bracket.
-
Release the RH 2nd row seat back from
the LH pivot, and then remove the seat back from the vehicle.
Install
-
Position the RH 2nd row seat back into
the vehicle, and then secure the seat back onto the LH pivot.
-
Slightly tilt the RH 2nd row seat back
upward, and then press the RH 2nd row pivot cast downward to secure it to the pivot
bracket.
-
Secure the RH 2nd row seat back pivot bushing onto the pivot bracket.
-
Install the clip that attaches the RH
2nd row seat back harness to the pivot bracket.
-
Connect the RH 2nd row seat back harness electrical connector.
- Fold the RH 2nd row seat to the up position.
- Install the RH 2nd row seat side bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
- Move the front passenger seat to its original position.
- Raise RH windows and close the RH doors.