2026-08-09

Actuator - Vane - Center Console - LH (Remove and Replace)

Correction code 18102712 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-10-16: Reorganized the procedure.

Remove

  1. Remove the center console air wave assembly. See Air Wave Assembly - Center Console (Remove and Replace).
  2. Remove the screws (x2) that attach the LH center console vane actuator to the center console, and then remove the actuator from the console.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • T20 bit

Install

  1. Position the LH center console vane actuator into the center console, and then install the screws that attach the actuator to the center console.
    1 Nm (.7 lbs-ft)
    Note
    Align the keyed socket with the flap gear.
    CAUTION
    Do not force the installation.
    Tip
    Use of the following tool(s) is recommended:
    • T20 bit
  2. Install the center console air wave assembly. See Air Wave Assembly - Center Console (Remove and Replace).