Cover - Shock Tower - LH (Remove and Replace)
Correction code
12251012
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
-
Release the clips (x3) that attach the
washer hose to the LH shock tower cover.
-
Release the clips (x4) that attach the
LH shock tower cover to the vehicle, and then remove the cover from the vehicle.
Install
-
Position the LH shock tower cover to
the vehicle, and then install the clips (x4) that attach the cover to the vehicle.
-
Position the washer hose to the LH
shock tower cover, and then install the clips (x3) that attach the washer hose to the
cover.
- Install the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).