2023-05-18

Sun Visor - LH (Remove and Replace)

Correction code 15051002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Release the clips (x4) that attach the sun visor bracket cover to the headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Extend the sun visor to increase the working area.
  2. Remove the screw that attach the sun visor to the vehicle.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 bit
  3. Release the sun visor from the headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Put the sun visor into the closed and folded down position, but do not latch in place.
  4. Disconnect the sun visor electrical connector, and then remove the visor from the vehicle.

Install

  1. Connect the sun visor electrical connector.
  2. Install the sun visor into the headliner.
  3. Install the screw that attaches the sun visor to the vehicle.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 bit
  4. Secure the clips (x4) that attach the sun visor bracket cover to the headliner.