2023-07-03

Mechanism - Pivot - Touchscreen (Remove and Replace)

21051222 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-06-28: Added option links to remove/install HW3 touchscreen and HW4 touchscreen.

Remove

  1. Remove the touchscreen.
  2. Remove and discard the bolts (x2) that attach the touchscreen pivot mechanism to the display housing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 2 in extension
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
  3. Remove the touchscreen pivot mechanism from the display housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift and tilt the mechanism off of the display housing.

Install

  1. Position the touchscreen pivot mechanism on the display housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tilt and lower the mechanism onto the display housing. Ensure the plastic washers are present.
  2. Install the new bolts (x2) that attach the touchscreen pivot mechanism to the display housing.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 2 in extension
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  3. Install the touchscreen.