Camera - Rear Facing (HW3) (Remove and Replace)
Correction code
17222002
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
-
Apply tape around liftgate tail lights
and applique
NoteApply tape to protect surrounding areas
- Remove the LH and RH reverse lights. See Light - Fog/Reverse - Rear - LH (Remove and Replace).
-
Remove the bolts (x2) that attach the
rear facing camera to the vehicle.
NoteTake note of the wiring harness routing for the rear facing camera.
- Disconnect the rear facing camera connector from the RH liftgate harness.
- Remove the grommet from the liftgate.
- Route the rear facing camera harness through the liftgate, and remove the camera from the vehicle.
Install
- Route the rear facing camera harness through the liftgate and position the camera to the vehicle.
- Position the grommet to the liftgate and harness.
- Connect the rear facing camera connector to the RH liftgate harness.
-
Using new bolts (x2), install the rear
facing camera to the liftgate bracket.
NoteT20, 1 Nm
- Install the LH and RH reverse lights. See Light - Fog/Reverse - Rear - LH (Remove and Replace).
- Remove all masking tape from the liftgate.
- Verify rear backup camera operation. If the camera does not operate correctly, disconnect LV power for 3 minutes. See LV Power (Disconnect and Connect).