2026-02-20

Airbag - Front Passenger (Remove and Replace)

Correction code 20010302 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2026-02-19: Added note on using PROC_RCM_DISARM if using this procedure to diagnose the SRS.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If using this procedure to diagnosis the vehicle's Supplemental Restraint Systems (SRS), disarm the RCM, which will prevent all airbags and pretensioners from deploying. Re-arm the RCM after all of the vehicle's SRS components are re-installed.
  • Disarm RCM:PROC_RCM_DISARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Disarm RCM
    • Safety & Restraints ➜ Seats ➜ Disarm RCM
    via Toolbox:(link)
  • Re-arm RCM:PROC_RCM_ARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Re-Arm RCM
    • Safety & Restraints ➜ Seats ➜ Re-Arm RCM
    via Toolbox:(link)

Remove

  1. Remove the RH air wave duct. See Duct - Instrument Panel - Front Passenger (Remove and Replace).
  2. Disconnect the front passenger airbag connectors (x3).
    Informational PurposesAn informational icon, calling your attention
    Note
    Simultaneously pull down the spring loaded locks to release the connectors.
  3. Remove and discard the bolts (x6) that attach the front passenger airbag to the vehicle, and then remove the airbag.
    Informational PurposesAn informational icon, calling your attention
    Note
    10mm, 8 Nm

Install

  1. Position the front passenger airbag on the vehicle, and then install new bolts (x6) that attach the airbag to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    10mm, 8 Nm
  2. Connect the electrical harnesses (x3) to the front passenger airbag.
  3. Install the RH air wave duct and all other parts that were removed for access. See Duct - Instrument Panel - Front Passenger (Remove and Replace).