17/06/2022 13:19:56

Trim - C-Pillar - Upper - LH (Remove and Replace)

Correction code 15186002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  2. Remove the LH and RH side bolster trims. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Remove and discard the lower bolt that attaches the LH 2nd row seat belt retractor to the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  5. Fold the LH 2nd row seat to the down position.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If seat cushion is not present, protect the seat as required.
  6. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  8. Release the clips (x7) that attach the LH upper C-pillar trim to the C-pillar, and then feed the seat belt through the trim to remove it from the vehicle.

Install

  1. Position the LH upper C-pillar trim to the C-pillar, feed the seat belt through the trim, and then fasten the clips (x7) that attach the trim to the vehicle.
  2. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  3. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  4. Fold the LH 2nd row seat to the up position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the seat cushion protection.
  5. Install a new lower bolt that attaches the LH 2nd row seat belt retractor to the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  6. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  7. Install the LH and RH side bolster trims. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  8. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).