17/06/2022 13:14:18

Seat Back - 2nd Row - LH (Remove and Replace)

Correction code 13054002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all the doors and lower all the windows.
  2. Move the front seats forward.
  3. Remove the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  4. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  5. Remove and discard the bolt that attaches the 2nd row center seat belt lower anchor to the vehicle, and then release the lower anchor from the vehicle.
    25 Nm (18.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  6. Fold the LH 2nd row seat to the down position.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the seat cushion is not present, protect the seat as required.
  7. Disconnect the LH 2nd row seat back harness electrical connector.
  8. Release the clip that attaches the LH 2nd row seat back harness to the pivot bracket.
  9. Release the pivot bushing that attaches the LH 2nd row seat back assembly to the pivot bracket.
  10. Slightly tilt the LH 2nd row seat back upward, and then pull the LH 2nd row pivot cast upward to release it from the pivot bracket.
  11. Release the LH 2nd row seat back from the RH pivot, and then remove the seat back from the vehicle.

Install

  1. Position the LH 2nd row seat back into the vehicle, and then secure the seat back into the RH pivot.
  2. Slightly tilt the LH 2nd row seat back upward, and then press the LH 2nd row pivot cast downward to secure it to the pivot bracket.
  3. Install the pivot bushing that attaches the LH 2nd row seat back assembly to the pivot bracket.
  4. Fasten the clip that attaches the LH 2nd row seat back harness to the pivot bracket.
  5. Connect the LH 2nd row seat back harness electrical connector.
  6. Fold the LH 2nd row seat to the up position.
  7. Install a new bolt that attaches the 2nd row center seat belt lower anchor to the vehicle.
    25 Nm (18.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  8. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  9. Install the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  10. Move the front seats to the original positions.
  11. Raise all the windows and close all the doors.