2022-06-17

Bracket - Rear Wing - LH (Remove and Replace)

Correction code 10016102 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).
  2. Remove the clips that attach the LH rear wing bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate clips counterclockwise, and then pull gently to release. The clips must be fully released to remove the bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • PH2 Phillips screwdriver
    • 6 in 90 degree pick
    • Plastic trim tool

Install

  1. Position the LH rear wing bracket onto the vehicle, and then install the clips.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push clips into the bracket, and then slightly rotate clockwise to secure.
  2. Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).