LED - Door - Exterior Handle - Rear - LH (Remove and Replace)
Correction code
11454702
0.66
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH rear door exterior release handle. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).
-
Disconnect the LH rear exterior handle
door LED harness electrical connector.
-
Release the clip that attaches the LH
rear exterior handle door LED harness to the handle assembly.
Install
-
Position the LH rear exterior handle
door LED harness onto the handle assembly, and then install the clip that attaches the
harness to the assembly.
-
Connect the LH rear exterior handle
door LED electrical connector.
- Install the LH rear door exterior release handle. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).