Scuff Plate - Rocker Panel - LH (Remove and Replace)
    
    
     Correction code
    
                                    12201602
                                    0.06
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
    Correction code
    
                                    12201602
                                    0.06
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
  
Remove
- 
          Carefully peel the LH body side
            secondary seal from the front of the LH rocker panel scuff plate, along its length, to
            the rear.
          
- 
          Release the clip that attaches the LH body side secondary seal to the rear of  the LH
            rocker panel scuff plate.
          NoteDo not completely remove the seal from the body.
- 
          Release the upper tabs (x7), and then
            the bottom clips (x7) that attach the LH rocker panel scuff plate to the LH rocker
            panel.
          
- 
          Slide the LH rocker panel scuff plate
            rearward, out from between the LH rear door and body, and then remove the scuff plate
            from the vehicle.
          
Install
- 
          Remove the adhesive strip from the LH
            body side secondary seal, and then clean the seal with an Isopropyl Alcohol (IPA) wipe.
            Allow 1 minute to dry.
          
- 
          Position the front end of the LH rocker panel scuff plate between the LH rear door
            and body, and then slide the scuff plate forward.
          
- 
          Fasten the bottom clips (x7), and then
            the upper tabs (x7) that attach the LH rocker panel scuff plate to the LH rocker
            panel.
          
- 
          Apply a new adhesive strip to the LH body side secondary seal where the previous
            strip was removed.
          
- 
          Fasten the clip that attaches the LH body side secondary seal to the rear of  the LH
            rocker panel scuff plate.
          
- 
          Press the body side secondary seal
            down onto the rear of the LH rocker panel scuff plate to attach the adhesive strip, and
            then press the length of the seal onto the scuff plate in a forward motion.