2022-06-17

Noise Absorber - Motor Bay - Rear (Remove and Replace)

Correction code 12010202 2.82 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear subframe assembly. See or Subframe Assembly - Rear (Plaid) (Remove and Install).
  2. Release the brake line from the clips (x4) in the rear motor bay.
  3. Release the rear motor bay brake line clips (x4) from the vehicle body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate counterclockwise to aid in removal.
  4. Release the clips (x6) that attach the rear motor bay noise absorber to body.
  5. Remove the rear motor bay noise absorber from the vehicle.

Install

  1. Install the clips (x6) that attach the rear motor bay noise absorber to the body.
  2. Secure the brake lines clips (x4) in the rear motor bay.
  3. Secure the rear motor bay brake line clips (x4) to the body.
  4. Install the rear subframe assembly. See or Subframe Assembly - Rear (Plaid) (Remove and Install).