17/06/2022 13:29:37

Horn Assembly (Remove and Replace)

Correction code 17531202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Release the clips (x7) that attach the front of the LH front wheel house liner to the vehicle, and then move the liner aside for access.
  4. Release the electrical connector from the low tone horn.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  5. Release the electrical connector from the high tone horn.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  6. Remove the nut that attaches the horn assembly to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    1x nut, 10mm

Install

  1. Install the nut that attaches the horn assembly to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    1x nut, 10mm, 12 Nm
  2. Connect the electrical connector to the high tone horn.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  3. Connect the electrical connector to the low tone horn.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  4. Install the clips (x7) that attach the LH front wheel house liner to the vehicle.
  5. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Remove the vehicle from the lift.