2023-07-06

Sensor - Shotgun Accelerometer - RH (Remove and Replace)

Correction code 20201252 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-07-05: Added tool info and fixed bad link.

Remove

  1. Disconnect LV power. See LV Power (Disconnect and Connect).
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  3. Disconnect the electrical connector from the RH headlight.
  4. Disconnect the electrical connector from the RH shotgun accelerometer sensor.
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  5. Remove the bolt that attaches the sensor to the vehicle, and then remove the sensor from the vehicle.

Install

  1. Position the sensor on the vehicle, and then install the bolt that attaches the sensor to the vehicle.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the locating tab on the sensor.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
    • Drive locking 6 in extension
  2. Connect the electrical connector to the RH shotgun accelerometer sensor.
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  3. Connect the electrical connector to the RH headlight.
  4. Connect LV power. See LV Power (Disconnect and Connect).
  5. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).