Panel - Aero Shield - Mid (Remove and Replace)
Correction code
12030502
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts (x16) that attach the mid aero shield panel to the vehicle |
![]() 6 Nm (4.4 lbs-ft) |
|
Reuse |
Remove
- Raise the vehicle. See Raise Vehicle - 2 Post Lift.
- Release the push clips (x2) that attach the mid aero shield panel to the LH and RH rear wheel arch liners.
- Release the push clips (x2) that attach the mid aero shield panel to the underbody.
-
Remove the bolts (x16) that attach the
mid aero shield panel to the rear subframe, and then remove the panel from the
vehicle.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- 4 in extension
- 10 mm socket
Install
- Apply a drop of Loctite 222 onto the threads of each mid aero shield panel bolt.
-
Install the mid aero shield panel to
the rear subframe, and then install the bolts (x16) that attach the panel to the
subframe.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- 4 in extension
- 10 mm socket
- Fasten the push clips (x2) that attach the mid aero shield panel to the underbody.
- Fasten the push clips (x2) that attach the mid aero shield panel to the LH and RH rear wheel arch liners.
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.