11/12/2023 09:56:12

Aero Lens - Instrument Panel (Remove and Replace)

Correction code 14050012 1.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-12-11: Added IP sub assembly step.
  • 2023-03-31: Added note on reworked datums/mounting tabs.
Informational PurposesAn informational icon, calling your attention
Note
Replacement aero lens assemblies may have had certain datums/mounting tabs removed. This is normal and does not negatively affect vehicle functionality.

Remove

  1. Remove the IP sub assembly. See Sub Assembly - Instrument Panel (Remove and Install).
  2. Remove the driver instrument panel air vent. See Air Vent - Instrument Panel - Driver (LHD) (Remove and Replace).
  3. Remove the screws (x4) that attach the front passenger instrument panel air vent to the aero lens assembly, and then remove the air vent from the assembly.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  4. Release the clip that attaches the LH instrument panel aero lens cover to the aero lens assembly, and then remove the cover from the assembly. Repeat this step for the RH aero lens cover.
    Figure 1. LH shown; RH similar
    Figure 2. LH shown; RH similar

Install

  1. Position the LH instrument panel aero lens cover to the aero lens assembly, and then secure the clip that attaches the cover to the assembly. Repeat this step for the RH aero lens cover.
    Figure 3. LH shown; RH similar
    Figure 4. LH shown; RH similar
  2. Position the front passenger instrument panel air vent onto the aero lens assembly, and then install the screws (x4) that attach the air vent to the assembly.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
  3. Install the driver instrument panel air vent. See Air Vent - Instrument Panel - Driver (LHD) (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to run the "Airwave" routine as instructed at the end of the air vent install.
  4. Install the IP sub assembly. See Sub Assembly - Instrument Panel (Remove and Install).