Light - Fog/Reverse - Rear - LH (Remove and Replace)
Correction code
17402702
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the liftgate applique. See Applique - Liftgate (Remove and Replace).
- Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Disconnect the LH rear fog/revers light electrical connector.
-
Remove the rubber covers (x2), and
then remove the nuts (x4) that attach the LH rear fog/reverse light to the
liftgate.4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- 8 mm socket
Install
-
Position the LH rear fog/reverse light into the liftgate, install the nuts (x4) that
attach the light to the liftgate, and then install the rubber covers (x2).4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- 8 mm socket
- Connect the LH rear fog/revers light electrical connector.
- Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Install the liftgate applique. See Applique - Liftgate (Remove and Replace).