2022-12-28

Grille - Speaker - Instrument Panel (Remove and Replace)

Correction Code: 14054702 1.14 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
  2. Remove the instrument panel windshield seal using a plastic trim tool.
  3. Remove the screws (x9) that attach the instrument panel speaker grille to the instrument panel sub-assembly.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Lift up to disengage, and then remove the instrument panel speaker grille from the instrument panel sub-assembly.

Install

  1. Engage the leading edge of the instrument panel speaker grille into the instrument panel sub-assembly, and then lower the grille into place.
  2. Install the screws (x9) that attach the instrument panel speaker grille to the instrument panel sub-assembly.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Install the instrument panel windshield seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Clean the windshield seal with an Isopropyl Alcohol (IPA) wipe, and then allow 1 minute to dry before continuing to the next step.
  4. Install the instrument panel sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).