17/06/2022 13:29:20

Wiper Module (Remove and Replace)

Correction code 17500102 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Use the touchscreen to put the wipers in "Wiper Service Mode".
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  4. Remove the LH and RH wiper arms. See Wiper Arm - LH (Remove and Replace).
  5. Remove the LH and RH shock tower covers. See Cover - Shock Tower - LH (Remove and Replace).
  6. Remove the wiper cowl screen panel. See Hose - Washer - Cowl Screen (Remove and Replace).
  7. Remove the LH shock tower V brace. See V Brace - Shock Tower - LH (Remove and Replace).
  8. Remove the bolts (x3) that attach the wiper module to the vehicle. Rotate the module forward and up to access the electrical connector, then disconnect the electrical connector from the wiper module.
    Informational PurposesAn informational icon, calling your attention
    Note
    3x bolts, 10mm, 8 Nm
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Carefully pivot the wiper module during removal to avoid damage to windshield.

Install

  1. Position the wiper module to the vehicle, and then connect the electrical connector to the wiper module. Install the bolts that attach the wiper module to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    3x bolts, 10mm, 8 Nm
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Carefully pivot the wiper module during installation to avoid damage to windshield.
  2. Install the LH shock tower V brace. See V Brace - Shock Tower - LH (Remove and Replace).
  3. Install the wiper cowl screen panel. See Hose - Washer - Cowl Screen (Remove and Replace).
  4. Install the LH and RH wiper arms. See Wiper Arm - LH (Remove and Replace).
  5. Install the LH and RH shock tower covers. See Cover - Shock Tower - LH (Remove and Replace).
  6. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  7. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  8. Use the touchscreen to disable the "Wiper Service Mode".