2022-06-17

Tube - Inlet - Coolant - Power Conversion System (Remove and Replace)

Correction code 16202002 4.86 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Torque Specifications

Table 1. Torque Specifications: Tube - Inlet - Coolant - Power Conversion System (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the power conversion system inlet tube to the HV battery front access cover
3 Nm (2.2 lbs-ft)
  • Torx T20 socket
Reuse

Remove

  1. Remove the HV battery front access cover. See Cover - Front Access - HV Battery (Remove and Install).
  2. Remove the bolts (x2) that attach the power conversion system inlet tube to the HV battery front access cover and remove the tube from the cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Inspect the condition of the rubber seal on the power conversion system inlet tube, and replace if damaged.
  2. Install the power conversion system inlet tube to the HV battery front access cover, and then install the bolts (x2) that attach the tube to the cover.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Install the HV battery front access cover. See Cover - Front Access - HV Battery (Remove and Install).