17/06/2022 13:30:38

Actuator - Intake (Remove and Replace)

Correction code 18102002 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the front windows.
  2. Remove the instrument panel sub-assembly. See Harness - Sub-Assembly - Instrument Panel (Remove and Replace).
  3. Remove the screws (x2) that attach the intake actuator to the vehicle.
    2.3 Nm (1.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 bit
  4. Cut and discard the zip tie that attaches the intake actuator to the HVAC harness, disconnect the actuator electrical connector, and then remove the actuator from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The HVAC harness is secured to the actuator leg without a screw.

Install

  1. Connect the intake actuator electrical connector, secure the harness to the actuator leg, route the harness on top of the actuator, and then secure the actuator to the harness with a zip tie.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove excess zip tie after tightening.
  2. Position the intake actuator onto the HVAC assembly, and then install the screws (x2) that attach the actuator to the assembly.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The actuator is keyed to the HVAC assembly. Make sure the actuator is properly aligned before installing the screws.
    Tip: Use of the following tool(s) is recommended:
    • T20 bit
  3. Install the instrument panel sub-assembly. See Harness - Sub-Assembly - Instrument Panel (Remove and Replace).
  4. Raise the front windows and close the LH front door.