2022-06-17

Decor - Trim - Rear Door - LH (Remove and Replace)

Correction code 15133202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Release the clips (x5) and hook that attach the LH rear door trim decor to the LH rear door trim panel, but do not pull the decor away from the door panel as there is still an electrical connector connected.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use a plastic trim tool to help release the metal crash clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Check for any clips still attached to the door panel.
  2. Release the electrical connector from the LH rear door trim panel, disconnect the electrical connector, and then remove the LH rear door trim decor from the assembly.

Install

  1. Position the LH rear door trim decor near the LH rear door trim panel, connect the electrical connector, and then secure the connector to the door panel.
  2. Engage the front hook on the LH rear door trim decor into the LH rear door trim panel, and then secure the clips (x5) that attach the decor to the door panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to pinch any wiring.