2022-06-17

Light - Fog - Front - LH (Remove and Replace)

Correction code 17404002 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Light - Fog - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the fog light to the front fascia assembly
2.8 Nm (2.1 lbs-ft)
  • Torx T25 socket
 Reuse

Remove

  1. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  2. Remove the three screws that attach the fog light to the front fascia assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
    • Flex head ratchet/flex head torque wrench
  3. Release the four clips that attach the fog light to the front fascia assembly, and then remove the fog light from the front fascia assembly.

Replace

  1. Position the fog light on the front fascia assembly, and then install the four clips that attach the fog light to the front fascia assembly.
  2. Install the three screws that attach the fog light to the front fascia assembly.
    2.8 Nm (2.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
    • Flex head ratchet/flex head torque wrench
  3. Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).